Blaupunkt Automobile Accessories RP4 CH11 User Manual

RP4-CH11  
Radio Replacement & Steering Wheel Control Interface  
for Chrysler/Dodge/Jeep Vehicles  
Introduction & Features  
The RP4-CH11 interface allows the replacement of a factory radio in select Chrysler/Dodge/Jeep vehicles with MSCAN or  
LSFT-CAN databus radios. Using this interface will retain factory features such as steering wheel controls (SWC) vehicle  
entertainment system (VES) and the factory audio amplifier whenever the original radio is removed. The RP4-CH11 also  
provides data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS), illumination,  
reverse trigger and parking brake.  
Important Notes  
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the  
interface into the vehicle (see next page for setting chart).  
2. When the interface is first plugged into the vehicle the LED will flash indicating the auto detect sequence. Once the CAN-BUS  
speed is detected the LED will illuminate and should be on at all times when the interface is on. The LED will also flash whenever  
a SWC button is pressed  
3. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless  
you wish to re-assign the SWC functions to different buttons. The SWC can always be restored to default settings by pressing  
and releasing the program button on the side of the interface once and waiting 7 seconds for the LED to flash 4 times.  
Wiring Connection Chart  
Vehicle Connector  
Interface Connector  
SWC Connector  
Red / White  
Purple / White  
Blue / White  
Red  
P.B. Output (-)  
VSS Output  
Yellow  
Black  
Battery +12v  
Ground  
Blu/Yel  
Kenwwod, Newer  
JVC, OEM or  
Blaupunkt  
Amp Turn On Input  
Acc. Output (1 amp)  
Illum. Output (+)  
Reverse Output (+)  
Blue  
Antenna On Input  
Front L + input  
Front L - input  
Front R + input  
Front R - input  
Rear L + input  
Rear L - input  
Rear R + input  
Rear R - input  
3.5mm Jack  
Alpine, JVC,  
Clarion, Pioneer,  
Sony, Valor, Boyo,  
Dual, Visteon or  
Advent  
White  
Orange / White  
Green  
White / Black  
Grey  
Grey / Black  
Green  
Green / Black  
Purple  
Purple / Black  
Illustration / Schematic  
Wiring  
SWC Connection  
Interface Connector  
See above chart for  
wire color descriptions.  
SWC Connection  
Vehicle Connector  
See above chart for  
wire color description.  
See above chart for  
different radio type  
connections  
Pacific Accessory Corporation® | Santa Ana, California 92705 | Ph. 866-931-8021 | [email protected]  
Rev. 112811  
©2011 Pacific Accessory Corporation  
 
Page 1  
RP4-CH11  
Radio Replacement & Steering Wheel Control Interface  
for Chrysler/Dodge/Jeep Vehicles  
Optional Steering Wheel Control Programming (cont.)  
Optional Programming Order  
Advent, Boyo, Dual,  
Visteon, Sony  
Alpine  
Volume +  
Volume -  
Mute  
JVC  
Volume +  
Volume -  
Mute  
Kenwood Clarion  
Volume + Volume + Volume +  
Volume - Volume - Volume -  
Valor  
OEM  
Volume +  
Volume -  
Mute  
Pioneer  
Volume +  
Volume -  
Mute  
Blaupunkt  
Volume +  
Volume -  
Mute  
1
2
3
Volume +  
Volume -  
Mute  
Mute  
Mute  
Mute  
4
5
6
7
8
9
Preset +  
Preset -  
Source  
Track +  
Track -  
Source  
Track +  
Track -  
Band/Disc +  
Preset/Disc -  
Select  
Source  
Play  
Track +  
Track -  
Source  
Search + Track +  
Search - Track -  
Source  
Source  
Next  
Previous  
Play/Ok  
Preset +  
Preset -  
Source  
Track +  
Track -  
Band  
Preset +  
Preset -  
Source  
Track +  
Track -  
Source  
Track +  
Track -  
Disc +  
Disc -  
Ok  
Band  
Up Cursor  
Disc/FM + Send/End Down Cursor Band  
Disc/AM - Send  
Power  
Ok  
Up Cursor  
Band  
10  
11  
12  
13  
14  
Enter/Play  
Band/Program Phone Receive  
Receive  
End  
Attenuation  
Answer  
End  
Down Cursor  
BT Answer  
BT Hangup  
Phone Menu  
Answer Call  
End Call  
Voice Activation  
Phone Reject  
Voice Dial  
Power  
Step B.  
Press and  
hold the  
Step A.  
Turn the vehicle ignition to  
the ON position.  
IGN  
ACC  
STRT  
OFF  
programming  
button.  
LED will turn off.  
Step D.  
Step C.  
Within 7 seconds,  
press and release the  
button that is to be  
The LED will  
turn off during  
this process.  
Release the  
programming  
button. The  
LED will turn  
back on.  
VOL  
learned on the steering  
wheel.  
The LED will turn on  
back on.  
Step E.  
Release the button.  
VOL  
Step F.  
If you need to program more buttons,  
repeat steps D & E for each additional  
audio function on the steering wheel.  
Program  
remaining buttons  
Once programming is  
completed, wait 7 seconds.  
The LED will flash four  
times indicating the end of  
programming.  
Step G.  
After all buttons are  
programmed  
x4  
Pacific Accessory Corporation® | Santa Ana, California 92705 | Ph. 866-931-8021 | [email protected]  
Rev. 112811  
©2011 Pacific Accessory Corporation  
 
Page 3  
RP4-CH11  
Radio Replacement & Steering Wheel Control Interface  
for Chrysler/Dodge/Jeep Vehicles  
Testing & Verification  
1. Turn the ignition on. The LED on the interface will turn on & the +12v accessory wire will turn on.  
2. Turn on the radio & check balance & fade. Note: Factory amplified Systems will not fade as neither the aftermarket radio or  
the RP interface have the ability to control the amplifier’s fader.  
3. Verify that the factory subwoofer (if present) is playing  
4. Verify that all SWC are functioning properly.  
4. Turn off vehicle & remove key. RAP will be active & keep the radio on for 10 minutes or until the drivers door is opened.  
5. The LED & radio will turn off when RAP turns off or the drivers door is opened.  
Vehicle Entertainment System (VES); If equipped  
1. Vehicles equipped with a DVD player built into the rear screen assembly:  
The RP4-CH11 will allow the VES DVD player and rear screen to function as if the factory radio were present. A/V will be passed  
from the factory DVD player to the rear screen and audio can be heard through the headphones. A/V cannot be passed from the  
factory DVD player to the aftermarket head unit.  
2. Vehicles equipped with a stand alone VES DVD Player:  
The RP4-CH11 will allow the VES DVD player and rear screen(s) to function as if the factory radio were present. A/V will be  
passed from the factory DVD player to the rear screen(s) and audio can be heard through the headphones. A/V can also be fed  
from the VES DVD player into an aftermarket head unit (head unit must support A/V in) with the use of the CHYRVD. It is VERY  
IMPORTANT that the RP4-CH11 Blue/White remote input wire be connected for this feature to function properly!  
3. Vehicles not equipped with a VES DVD Player (rear screen(s) only):  
In this application the CHYRVD must be used in order to feed A/V into the factory screen(s) from an aftermarket head unit (head  
unit must support A/V out). With the CHYRVD, A/V will be passed from the aftermarket head unit to the rear screen(s) and audio  
can be heard through the headphones. If you wish to retain the Auxiliary inputs on the rear of the console you must disconnect  
the factory wires from the auxiliary input then connect and run your own RCAs into the aftermarket head unit.  
4. Vehicles equipped with a Reverse Camera:  
In order to retain the factory reverse camera the CHYRVD must be used to feed video into the aftermarket head unit (head unit  
must support reverse camera input).  
Product Updates (Firmware)  
The RP4-CH11 can be updated with new firmware as it becomes available using the PAC-UP interface updater (sold seperatly).  
Pacific Accessory Corporation® | Santa Ana, California 92705 | Ph. 866-931-8021 | [email protected]  
Rev. 112811  
©2011 Pacific Accessory Corporation  
 
Page 4  

Belkin Vacuum Cleaner F8E426 User Manual
BenQ Projection Television PB2220 PB2120 User Manual
Boss Audio Systems Car Stereo System BV9967BI User Manual
Braun Food Processor K 600 User Manual
Califone DJ Equipment PA419 User Manual
Canon Camera Lens HJ22EX76B User Manual
Canon Digital Camera SX160 IS User Manual
Casio Digital Camera EX G1 User Manual
Casio GPS Receiver OMC771 User Manual
Cecilware Hot Beverage Maker GB5MV 10 LD User Manual